6. Close the Ink Tank Cover.
At this point, ink is drawn out from inside the tubes.
Important
･ Do not remove the Maintenance Cartridge during this process.
When the process is finished, "Completed! Turn Power Off!!" is displayed.
Pack the printer
1.
Press the Power button and turn off the printer.
Important
･ Turn off the printer before you unplug it. It may damage the printer
if you unplug it before it is off and transfer it in that state. If you
accidentally unplug the printer, plug it in again, reinstall the ink tanks,
and follow this procedure again.
2. Disconnect the power cord and interface cable.
3. Tape down printer covers to secure them, in the reverse order of tape removal during
installation.
4. Remove the Stand by reversing the installation procedure, when it was attached to the
printer.
5. Disassemble and repackage the Stand by following the installation procedure in reverse.
6. Repack the Roll Holder, Holder Stopper, and printer in shipping materials, and then package
To Next Page
Loading...
