11. 5. 4. Troubleshooting > Problems with the printing quality >
The surface of the paper is dirty
Cause Corrective Action
The Paper Retainer is
soiled.
Clean the Paper Retainer.
(See "Cleaning Inside the Top Cover (10.4.2).")
You are using a paper
that does not dry easily.
In the Control Panel menu, set Roll
DryingTime to at least 1 min.
(See "Menu Settings (8.2.8).")
When paper that does not dry easily is used for
printing, it may curl during printing and touch
the Output Tray.
In this case, in the Control Panel menu, set
Scan Wait Time to an option other than Off.
However, note that printing will now take longer.
(See "Menu Settings (8.2.8).")
To Next Page
Loading...
Need help?
General