7. After confirming that DEasy Settings is selected, click CAD (Color Line Drawing) or CAD
(Monochrome Line Drawing ) in the
EPrint Target list.
Note
･ You can check the settings values selected in the
EPrint Target list by
clicking
GView set..
8. Make your selection in the FPrint Quality list.
9. Access the Page Setup pane.
10. Click Roll Paper in the APaper Source list.
11. Make sure the width of the loaded roll is displayed in the BRoll Width list-in this case, ISO A2/
A3 (420.0mm).
Note
･ If the width of the roll loaded in the printer is not shown in
BRoll Width,
click
LPrinter Information on the Main pane to update the printer
information.
To Next Page
Loading...
