On
Printed
The type and amount of paper left is
automatically detected based on the
barcode printed on the roll.
There is no need to specify the type and
length of the paper.
Not printed
A menu for selection of the paper type and
length is automatically shown on the
Display Screen.
Press or to select the type and length
of paper loaded, and then press the OK
button.
Note
ï½¥ For details on types of paper to select (See "Types of Paper (
6.1.1).")
8. Holding it at the positions indicated, close the Roll Cover.
Note
ï½¥ Cut the edge of the roll after the paper is advanced if it is soiled or if there are
cuts from scissors or the blade after removing creased edges. (See "Specifying the
Cutting Method for Rolls (
6.2.13).")
To Next Page
Loading...
Need help?
General