Adjust
Printer
Head Posi. Adj.
Auto(Advanced)
The printer prints and reads a test
pattern for the automatic adjustment
of Printhead alignment relative to the
printing direction and spacing
between nozzles and colors. (See
"Automatic Adjustment to Straighten
Lines and Colors (Head Posi.
Adj.) (
7.1.2).")
Manual
Print a test pattern for adjustment of
Printhead alignment relative to the
printing direction. Enter the
adjustment value manually based on
the resulting pattern. (See "Manual
Adjustment to Straighten Lines and
Colors (Head Posi. Adj.) (
7.1.3).")
Head Inc. Adj.
Print a test pattern for adjustment of
the Printhead orientation. (See
"Adjusting Line Misalignment (Head
Inc. Adj.) (
7.1.4).")
Feed Priority
Adj.
Priority
Automatic
Specify exact paper feeding, if
desired. Normally, select Automatic.
Choose Print Quality for attractive
printing. Choosing Print Quality also
makes banding less noticeable.
Choose Print Length if you prefer to
feed the paper an exact amount.
However, note that slight banding
may occur in the direction of carriage
scanning when Print Length is
selected.
Print Quality
Print Length
Adj.
Quality
Auto(GenuinePpr)
Specify this mode with paper
identified in the Paper Reference
Guide.
The printer prints and reads a test
pattern for automatic adjustment of
the feed amount. (See "Automatic
Banding Adjustment (Adj.
Quality) (
7.2.3).")
Auto(OtherPaper)
Specify this mode with paper not in
the Paper Reference Guide.
The printer prints and reads a test
pattern for automatic adjustment of
the feed amount. Note that this
function takes more time and
consumes more ink than Auto
(GenuinePpr). (See "Automatic
Banding Adjustment (Adj.
Quality) (
7.2.3).")
Manual
Use this mode with highly transparent
media or other paper for which Auto
(GenuinePpr) or Auto
(OtherPaper) cannot be used.
Print a test pattern for adjustment of
the feed amount based on the type of
paper. (See "Manual Banding
Adjustment (Adj. Quality) (
7.2.4).")
AdjustmentPrint
A:High
Print a test pattern for particular types
of paper to compensate for paper
stretching or shrinkage, after which
you enter the amount of adjustment.
(See "Adjusting Line Length (Adjust
Length) (
7.2.6).")
To Next Page
Loading...
Need help?
General