9. 1. 9. Network Setting > Network Setting >
Configuring the Printer's AppleTalk Network Settings
Follow the steps below to configure the AppleTalk network settings.
1. Start the web browser and enter the following URL in the Location (or Address ) box to
display the RemoteUI page.
http://printer IP address or name/
Example: http://xxx.xxx.xxx.xxx/
2. Select Administrator Mode and click Logon.
3. If a password has been set on the printer, enter the password.
4. Click Network in the Device Manager menu at left to display the Network page.
5. Click Edit in the upper-right corner of the AppleTalk group to display the Edit AppleTalk
Protocol Settings page.
6. Refer to the AppleTalk Settings Items table to complete the settings.
AppleTalk Settings Items
Item Details Default Setting
Phase Type
Specify whether to use
AppleTalk.
If you will use AppleTalk,
choose Phase 2.
If you will not use AppleTalk,
choose Disabled.
Disabled
Name (*1)
Specify the object name used
by AppleTalk (in up to 31
single-byte or 15 double-byte
characters).
However, do not use the
following single-byte
characters: @, *, :, and =.
Océ NB-18GB (xxxxxx)
Zone (*2)
Specify the printer zone
name, up to 31 single-byte
characters.
However, do not use the
following single-byte
characters: Also avoid using *
(which represents the default
zone) in the middle of a
string.
*
To Next Page
Loading...
Need help?
General