– 100 – NWA-008845-001 Rev.5.0
32ch1002.fm
To provide an external Call Waiting Indicator:
DESCRIPTION DATA
Assign the incoming call to queuing mode
when all ACD stations are busy.
(1)
(2)
212
1: Queuing
Specify the maximum number of queuing in
each ACD group for controlling external indi-
cator lamp.
(1)
(2)
15
01-99 : 1 call-99 calls
NONE : 1 call
NOTE: Depending on the number of queuing station/trunk, lamp indication pattern on the external
indicator is different as shown below:
N=Number of queuing station/trunk
Assign the DK card to the required LEN.
NOTE 1: The DK card number must be
assigned to the first LEN (Level 0)
and the third LEN (Level 2) of each
LT slot.
(1)
(2)
000-763: LEN
E800-E831 : DK card No.
For PIM0/1: E800-E807
For PIM2/3: E808-E815
For PIM4/5: E816-E823
For PIM6/7: E824-E831
NOTE 2: Circuit No. 3 of E831 is used for
built-in External Equipment Interface
on MP card by setting CM44.
Assign the DK card to the required LEN.
[Series 3200 R6.2 software required]
NOTE 1: The DK card number must be
assigned to the first LEN (Level 0)
and the third LEN (Level 2) of each
LT slot.
(1)
(2)
XX ZZZ: LEN
XX : 00-59: FP No.
ZZZ: 000-127: Port No.
E800-E831 : DK card No.
For FP No. 00 : E800-E807
For FP No. 01 : E808-E815
For FP No. 02 : E816-E823
For FP No. 03 : E824-E831
NOTE 2: Circuit No. 3 of E831 is used for
built-in External Equipment Interface
on MP card by setting CM44.
START
CM08
CM42
CONDITIONS LAMP INDICATION
2nd Data=01 Lamp on irrespective of number of queuing station/trunk (For the
indication pattern, see CM59 in next page.)
N<2nd Data (2nd Data≠01) Lamp off
2nd Data≤N (2nd Data≠01) Lamp on (For the indication pattern, see CM59 in next page.)
CM10
CM14
A
AUTOMATIC CALL DISTRIBUTION (ACD)
CALL WAITING INDICATION-ACD
To Next Page
Loading...