– 25 – NWA-008845-001 Rev.5.0
32ch1001.fm
ALPHANUMERIC DISPLAY
PROGRAMMING
DESCRIPTION DATA
Provide the system with the Name Display
Service.
(1)
(2)
255
1: To provide
Provide station number and name display
when an incoming call terminates to a Prime
Line and a My Line.
(1)
(2)
335
0 : Station No. and name display only
when incoming call terminates to
Prime Line
1 : Station No. and name display when in-
coming call terminates to Prime Line
or My line
Assign the access code for Name Display. •
(1)
(2)
Y=0-3 Numbering Plan Group 0-3
X-XXXX: Access Code (62)
A110
See NAME DISPLAY REGISTRATION
FROM D
term
. Page 53
Specify the time to go back to Date and Time
display after the call answered.
(1)
(2)
120
0 : 10 seconds later
1 : 6 seconds later
Specify the duration to display the name. (1)
(2)
121
0 : Until call finished
1 : As per CM08>120
Specify the duration of displaying the name
when the incoming call is answered/the select
key for Calling Number Display and Calling
Name Display or CID key is pressed.
[Series 3300 software required]
(1)
(2)
537
0 : Until call is finished/key is pressed
again
1 : 6 seconds
Specify the duration of displaying the destina-
tion information when the outgoing call is an-
swered by the destination via CCIS/ISDN.
[Series 3300 software required]
(1)
(2)
538
0 : Until call is finished
1 : 6 seconds
Assign a trunk name number to each trunk
route.
•
(1)
(2)
Y=03
00-63: Trunk Route No.
00-14: Trunk Name No. 00-14
15 : Kind of trunk route assigned by
CM35 Y=00 is displayed
16-63: Trunk Name No. 16-63
START
CM08
INITIAL
CM20
CM08
CM35
A
JANUARY/20/2006
ALPHANUMERIC DISPLAY
To Next Page
Loading...