– 384 – NWA-008845-001 Rev.5.0
32ch1007.fm
FLEXIBLE LINE KEY ASSIGNMENT
PROGRAMMING
For the applicable feature programming on Flexible Line Key, refer to each feature:
• DO NOT DISTURB Page 346
• HOTLINE-INSIDE/OUTSIDE Page 407
• INTERCOM Page 414
• PROPRIETARY MULTILINE TERMINAL Page 566
• SAVE AND REPEAT Page 600
• STATION SPEED DIALING Page 665
• TRUNK-DIRECT APPEARANCES Page 709
To indicate the busy/idle status of the extensions accommodated to the Flexible Line Keys on the Series E
Terminal without the One Touch Speed Dial Keys, assign the following data. Station Speed Dialing mem-
ory and One Touch Key memory assignment are used to implement this feature.
DESCRIPTION DATA
Assign Service Restriction Class A to each sta-
tion.
•
(1)
(2)
Y=02
X-XXXXXXXX: Station No.
XX ZZ
XX: 00-15 : Service Restriction Class A
Allow Station Speed Dialing in Service Re-
striction Class A assigned by CM12 Y=02.
•
(1)
(2)
Y=07
00-15: Service Restriction Class A as-
signed by CM12 Y=02
1 : Allow
START
CM12
CM15
A
FLEXIBLE LINE KEY ASSIGNMENT
To Next Page
Loading...