– 238 – NWA-008845-001 Rev.5.0
32ch1004.fm
MEET-ME CONFERENCE
To attend a conference by accessing from any station or trunk to the conference trunk, do the following
programming in addition to the Conference Trunk Assignment ( Page 228).
DESCRIPTION DATA
Specify whether Service Set Tone is sent to
participants when a new participant attends the
conference.
[Series 3500 software required]
(1)
(2)
728
0: Not sent
1: To send
Assign a Numbering Plan Group number to
each tenant.
(1)
(2)
00-63: Trunk Route No.
710-713: Numbering Plan Group 0-3
Assign the access code for LCR Group 0-3. •
(1)
(2)
Y=0-3 Numbering Plan Group 0-3
X-XXXX: Access Code
A126: LCR Group 0
A127: LCR Group 1
A128: LCR Group 2
A129: LCR Group 3
Assign the access code for Restriction of addi-
tional participants to conference Set and Can-
cel, respectively.
[Series 3500 software required]
•
(1)
(2)
Y=0-3 Numbering Plan Group 0-3
X-XXXX: Access Code
A254: Restriction of additional participants
to conference Set
A255: Restriction of additional participants
to conference Cancel
Assign an Area Code Development Pattern
number to each LCR Group.
•
(1)
(2)
Y=A000
0-3: LCR Group 0-3
4000-4007: Area Code Development Pat-
tern No. 0-7
Assign a Route Pattern number to each area
code (Meet-Me Conference Access Code) for
the Area Code Development Pattern number
assigned by CM8A Y=A000.
•
(1)
(2)
Y=4000-4007 Area Code Development
Pattern No. 0-7
X...X: Area Code (Meet-Me Conference
Access Code), Maximum 8 digits
0000-0255: Route Pattern No. 000-255
Specify the order of LCR selection for the
Route Pattern number assigned by CM8A
Y=4000-4007.
•
(1)
(2)
Y=0000-0255 Route Pattern No. 000-255
1-4: Order of LCR Selection
1: 1st
2: 2nd
3: 3rd
4: 4th
XXX ZZ
XXX: 000-255: LCR Pattern No. 000-255
ZZ : 00-63: Trunk Route No. 00-63 as-
signed by CM30 Y=00
START
CM08
CM29
CM20
CM8A
A
CONFERENCE (32-PARTY)
MEET-ME CONFERENCE
To Next Page
Loading...