– 199 – NWA-008845-001 Rev.5.0
32ch1004.fm
CID CALL BACK
PROGRAMMING
DESCRIPTION DATA
Specify Message Waiting Lamp indication on
the D
term
to which Message Waiting/Message
Reminder is set.
(1)
(2)
294
0 : Flashing 60 IPM
1 : Steady Lighting
Specify the time display for Message Waiting/
Message Reminder on D
term
with LCD.
(1)
(2)
280
0: 24-Hour
1: 12-Hour
Provide the system with CID Call Back. (1)
(2)
493
0: To provide
Specify whether CID Call Back is provided or
not when an incoming call is forwarded, when
a station to which a call is terminated is busy,
or a station to which a call terminated is set Do
Not Disturb.
[Series 3900 software required]
NOTE: CID Call Back by this command is
available under the following condi-
tions.
•The D
term
station line is set to
Call Forwarding-All Calls/Call
Forwarding-Busy Line/Call For-
warding-No answer/Call For-
warding-D
term
IP logout when a
trunk call is terminated.
•The D
term
station line is set to Do
Not Disturb when a trunk call is
terminated.
•The D
term
station line received
the incoming call is busy when a
trunk call is terminated.
(1)
(2)
588
0: To provide
1: Not provided
START
CM08
A
JUNE/01/2007
CID CALL BACK
To Next Page
Loading...