Philips Sopho 2000 IPS - Call Forwarding

– 136 – NWA-008845-001 Rev.5.0
32ch1003.fm
CALL FORWARDING
To set or reset the Call Forwarding service from a MAT/CAT, use the following command.
DESCRIPTION DATA
Use Y=00-03 for Call Forwarding and Y=04-
05 for Split Call Forwarding. To reset the
service, assign “CCC” to the second data of
each Y No.
•
•
•
•
(1)
(2)
Y=00 Call Forwarding-All Calls
Y=01 Call Forwarding-Busy Line
Y=02 Call Forwarding-No Answer
Y=03 Call Forwarding-Busy Line/No An-
swer
X-XXXXXXXX: Station No.
Destination No.
<Destination=Extension>
X-XXXXXXXX: Station No.
<Destination=Outside Party>
X-XXXX + + YY···Y
X-XXXX: Outgoing Trunk/LCR Group
Access Code (1-4 digits)
: Separate Mark
YY···Y : Called No. (Maximum 26
digits)
<Destination=Attendant>
E000: Attendant Console
•
•
(1)
(2)
Y=04 Split Call Forwarding-ALL Calls
Y=05 Split Call Forwarding-Busy Line/No
Answer
X-XXXXXXXX: Station No.
0: Target Station for Split Call Forwarding
(Block 0)/ATT
1: Target Station for Split Call Forwarding
(Block 1)
2: Target Station for Split Call Forwarding
(Block 2)
3: Target Station for Split Call Forwarding
(Block 3)
4: Target Station for Split Call Forwarding
(Block 4)
5: Target Station for Split Call Forwarding
(Block 5)
6: Target Station for Split Call Forwarding
(Block 6)
7: Target Station for Split Call Forwarding
(Block 7)
8: Target Station for Call Forwarding
9: Station Speed Dialing (Block 0)
START
CME6
,
,
END
CALL FORWARDING