– 202 – NWA-008845-001 Rev.5.0
32ch1004.fm
CID CALL ROUTING
PROGRAMMING
For DID on ISDN, T1-ANI, MFC incoming calls:
(See SAMPLE DATA PROGRAMMING 1. Page 207)
DESCRIPTION DATA
Provide the incoming trunk route with digit
conversion.
•
(1)
(2)
Y=18
00-63: Trunk Route No.
0: To provide
Specify the Development Table for digit con-
version.
•
(1)
(2)
Y=170
00-63: Trunk Route No.
0 : Development Table 1
3 : Development Table 0
Assign the Number Conversion Block number
for Development Table 0.
•
(1)
(2)
Y=00
X-XXXX: DID No. /Called No.
000-999: Number Conversion Block No.
NOTE
NOTE: When the Number Conversion Block number is assigned for CID Call Routing, do not use
the same Number Conversion Block number for the DID feature.
Assign the Number Conversion Block number
for Development Table 1.
•
(1)
(2)
Y=90
X-XXXXXXXX: DID No. /Called No.
000-999: Number Conversion Block No.
NOTE
NOTE: When the Number Conversion Block number is assigned for CID Call Routing, do not use
the same Number Conversion Block number for the DID feature.
START
CM35
CM76
A
CID CALL ROUTING
To Next Page
Loading...