– 394 – NWA-008845-001 Rev.5.0
32ch1007.fm
FORCED ACCOUNT CODE
PROGRAMMING
DESCRIPTION DATA
Specify the processor for Forced Account
Code.
(1)
(2)
216
0: MP card
1 : OAI (ACF)
Specify whether Service Set Tone is provided
after dialing the access code for Forced Ac-
count Code.
(1)
(2)
362
0: No tone
1 : Service Set Tone
Assign Service Restriction Class A for Forced
Account Code to required stations.
•
(1)
(2)
Y=02
X-XXXXXXXX: My Line No.
XX ZZ
XX: 00-15 : Service Restriction Class A
Allow Forced Account Code in Service Re-
striction Class A assigned by CM12 Y=02.
•
(1)
(2)
Y=31
00-15: Service Restriction Class A as-
signed by CM12 Y=02
1 : Allow
Specify the entry of Forced Account Code
after dialing an LCR access code and desired
number.
[Series 3900 software required]
NOTE: To provide this operation, the
following data assignments are
required.
- Toll restriction
(CM12 Y=01,
CM8A Y=5XXX: 000, CM81)
- LCR origination
(CM20: A126/A127/A128/A129,
CM8A Y=5XXX: 180, CM85)
•
(1)
(2)
Y=401
00-15: Service Restriction Class A as-
signed by CM12 Y=02
1 : Allow
7 : Restricted
Assign the access code for Forced Account
Codes.
•
(1)
(2)
Y=0-3 Numbering Plan Group 0-3
X-XXXX: Access Code
A087
START
CM08
CM12
CM15
CM20
A
JUNE/01/2007
FORCED ACCOUNT CODE
To Next Page
Loading...