– 393 – NWA-008845-001 Rev.5.0
32ch1007.fm
To set the ringing tone setting by Day Mode/Night Mode, do the following programming.
[Series 3700 R12.2 software required]
DESCRIPTION DATA
Provide the change the ringing tone depend on
Day Mode/Night Mode Change.
(1)
(2)
577
0: To provide
Apply Day Mode/Night Mode to all D
term
s.
NOTE 1: This data is effective only when the
2nd data is set to 0.
NOTE 2: This command is performed after
CM08>577 is set, or when the sta-
tion tenant number of My Line is
changed by CM12 Y=04.
•
(1)
(2)
Y=9
0
0 : Start to apply
1 : Now applying
3 : Stand by
Assign the setting of D
term
ringing tone by Day
Mode/Night Mode.
•
(1)
(2)
Y=02
My Line No. + + Key No. (01-24)
0 : Day Mode: No ringing/Night Mode:
No ringing
1 : Day Mode: Ringing/Night Mode:
Ringing
2 : Day Mode: No ringing/Night Mode:
Ringing
3 : Day Mode: Ringing/Night Mode: No
ringing
START
CM08
CMEC
CM90
,
END
JULY/01/2006
FLEXIBLE RINGING ASSIGNMENT
To Next Page
Loading...