– 45 – NWA-008845-001 Rev.5.0
32ch1001.fm
ATTENDANT CAMP-ON
PROGRAMMING
To reenter a Camped-On trunk from an Attendant before Automatic Recall:
DESCRIPTION DATA
Specify Attendant Camp-On as a type of
Camp-On to activate from the Attendant Con-
sole.
[Series 3400 software required]
(1)
(2)
542
1 : Attendant Camp-On
Specify the Camp-On Tone sent to busy
station
(1)
(2)
068
0 : Camp-on Tone is sent out only once.
1 : Camp-on Tone is repeated at an inter-
val of 4 seconds.
Specify the recall timing of Camp-On. •
(1)
(2)
Y=0
00
01-14: 2.4-33.6 seconds
(2.4 second increments)
15-24: 38.4-124.8 seconds
(9.6 second increments)
If no data is set, the default setting is 31.2-33.6
seconds.
DESCRIPTION DATA
Assign the access code for Call Pickup-Direct. •
(1)
(2)
Y=0-3 Numbering Plan Group 0-3
X-XXXX: Access Code
A021: Call Pickup-Direct
START
CM08
CM41
END
START
CM20
END
ATTENDANT CAMP-ON
To Next Page
Loading...