– 303 – NWA-008845-001 Rev.5.0
32ch1006.fm
DID DIGIT CONVERSION
PROGRMMING SUMMARY FOR DID DIGIT CONVERSION
(1) Specify whether the DID Digit Conversion is provided for each trunk route by CM35 Y=18.
(2) To provide the DID Digit Conversion, set the following data.
STEP1: Specify the Development Table for DID Digit Conversion to each trunk route by CM35 Y=170.
STEP2: Assign the number of digits to be received on DID and the number of digits to be converted on
DID to each trunk route/each Development Table by CM35 Y=12, 78/CM35 Y=171, 172.
STEP3: Set the Number Conversion Block number for each Development Table by CM76 Y=00, 90.
STEP4: Assign the data for interpreting the received digits to each Number Conversion Block number
by CM76 Y=01-04.
DID Digit Conversion Programming Procedure
Received number=Station number
DID station
CM35 Y=18
0: To provide DID Digit Conversion
CM35 Y=170
CM35 Y=12
Number of
digits to be
received:
1-4 digits
CM35 Y=78
Number of
digits to be
converted:
2-4 digits
CM76 Y=00
DID number
Number
Conversion
Block number
0: Development
Table 1
CM35 Y=172
Number of
digits to be
received:
1-14 digits
CM35 Y=171
Number of
digits to be
converted:
1-8 digits
CM76 Y=90
DID number
Number
Conversion
Block number
1 : Not provided DID Digit Conversion
DID station
3 : Development
Table 0
CM76
Y=01-04
The data setting
for interpreting
the digits re-
ceived to each
Number Con-
version Block
number
DIRECT INWARD DIALING (DID)
DID DIGIT CONVERSION
To Next Page
Loading...