– 539 – NWA-008845-001 Rev.5.0
32ch1009.fm
OVERFLOW FOR TAS QUEUE
PROGRAMMING
In addition to the TAS programming ( Page 543), do the following programming.
HARDWARE REQUIRED
When a DAT is used as the destination of Call Forwarding:
DAT card or MP card (built-in DAT)
DESCRIPTION DATA
Assign the destination of Call Forwarding by
Overflow for TAS Queue.
•
•
•
•
(1)
(2)
Y=26 Day Mode
Y=27 Night Mode
Y=28 Mode A
Y=29 Mode B
00-63: Tenant No.
X-XXXXXXXX: Station No.
E000 : Attendant Console
EB000-EB127 : Digital Announcement
Trunk No. assigned by
CM10/CM14
Specify the timing of Call Forwarding by
Overflow for TAS Queue.
•
(1)
(2)
Y=0
42
01-99: 4-396 seconds
(4 second increments)
If no data is set, the default setting is 28-32 sec-
onds.
When a call is forwarded to the VMS/station/
Attendant Console by Overflow for TAS
Queue, assign the Call Forwarding setting sta-
tion number, which is sent to the destination.
•
(1)
(2)
Y=30
00-63: Tenant No.
X-XXXXXXXX: Station No.
When a Digital Announcement Trunk is set as
the destination of Call Forwarding, set the
function of the Digital Announcement Trunk
as announcement service for Overflow for
TAS Queue.
•
(1)
(2)
Y=00
000-001: Built-in DAT on MP card
002-127: Digital Announcement Trunk
Card No. (EB002-EB127) as-
signed by CM10/CM14
1800: Announcement Service for Overflow
for TAS Queue
START
CM51
CM41
CM51
CM49
END
NIGHT SERVICE
OVERFLOW FOR TAS QUEUE
To Next Page
Loading...