– 715 – NWA-008845-001 Rev.5.0
32ch1011.fm
TRUNK QUEUING-OUTGOING
PROGRAMMING
NOTE: To provide Trunk Queuing-Outgoing in conjunction with Least Cost Routing-3/6 Digit, you
must set Route Pattern No. 000-126 (CM8A Y=0000-0126). Route Pattern No. 127-255 cannot
be used for Trunk Queuing-Outgoing with Least Cost Routing-3/6 Digit.
DESCRIPTION DATA
Assign Service Restriction Class A for Trunk
Queuing-Outgoing to the required stations.
•
(1)
(2)
Y=02
X-XXXXXXXX: Station No.
XX ZZ
XX: 00-15 : Service Restriction Class A
Allow Trunk Queuing-Outgoing in Service
Restriction Class A assigned by CM12 Y=02.
•
(1)
(2)
Y=02
00-15: Service Restriction Class A as-
signed by CM12 Y=02
1 : Allow
Assign the access code for setting and resetting
this service.
•
(1)
(2)
Y=0-3 Numbering Plan Group 0-3
X-XXXX: Access Code (*1, #1)
• If a different access code from Call Back
is used.
A000: Set
A001: Reset
• If the same access code as Call Back is
used.
A004: Set
A005: Reset
Assign the Trunk Queuing-OG (Call Back)
key to the required D
term
.
•
(1)
(2)
Y=00
My Line No. + + Key No.
F0000: Trunk Queuing-OG
F0004: Trunk Queuing-OG/Call Back
Specify the Trunk Queuing-Outgoing capabil-
ity for each trunk route.
•
(1)
(2)
Y=28
00-63: Trunk Route No.
0 : Restricted
1 : Allow
START
CM12
CM15
CM20
CM90
,
CM35
END
TRUNK QUEUING-OUTGOING
To Next Page
Loading...