– 540 – NWA-008845-001 Rev.5.0
32ch1009.fm
QUEUE LIMIT FOR TAS
PROGRAMMING
In addition to the TAS programming ( Page 543), do the following programming.
DESCRIPTION DATA
Assign the number of Queue Limit for TAS to
each mode and tenant.
•
•
•
•
(1)
(2)
Y=3 Day Mode
Y=4 Night Mode
Y=5 Mode A
Y=6 Mode B
00-63: Tenant No.
01-99 : 1-99 lines
NONE : No limit
Specify the terminating system as TAS. •
•
•
•
(1)
(2)
Y=01 Day Mode
Y=02 Night Mode
Y=03 Mode A
Y=04 Mode B
000-999: Number Conversion Block No.
assigned by CM76 Y=00/90
D13: TAS
Specify whether the incoming call of each DID
number is restricted by Queue Limit for TAS.
NOTE: When there are two or more DID
numbers for one tenant, and if you
want to set the Queue Limit only for
one DID number, set “0” to the DID
number, and set “3” for the other
DID numbers.
If you want to set the Queue Limit
for one DID number and the other
DID numbers concurrently, set “0”
to the DID number, and set “2” to
the other DID numbers.
•
(1)
(2)
Y=16
000-999: Number Conversion Block No.
assigned by CM76 Y=00/90
0:Restricted
2 : Not restricted
(countable for Queue Limit)
3 : Not restricted
(uncountable for Queue Limit)
START
CM64
CM76
A
NIGHT SERVICE
QUEUE LIMIT FOR TAS
To Next Page
Loading...