Philips Sopho 2000 IPS - Page 173

– 155 – NWA-008845-001 Rev.5.0
32ch1003.fm
DESCRIPTION DATA
To apply this feature to incoming calls, set the
trunk route combinations for Tandem Connec-
tion.
•
(1)
(2)
Y=05
00-63: Trunk Route No. NOTE
1 : Release signal arrives NOTE
NOTE: For Resident System Programming,
refer to the Command Manual.
•
(1)
(2)
Y=0
Incoming Trunk Route No. + Outgoing
Trunk Route No. assigned by CM35 Y=05
0: Allow
Specify the setting method for Call Forward-
ing-Busy Line-Outside.
(1)
(2)
222
0 : Setting when the station goes on hook/
when receiving Service Set Tone
(ORT time out)
1 : Setting when receiving Service Set
Tone (ORT time out)
Allow or restrict the ability to set Call
Forwarding-Busy Line for a station with Do
Not Disturb set.
(1)
(2)
240
0 : Allowed
1 : Restricted
Assign whether an extension can set a destina-
tion of Split Call Forwarding-Busy Line-
Outside by entering only a trunk access code.
(1)
(2)
386
0 : Restricted
1 : Allowed
Select the trunk route seized for Split Call
Forwarding-Busy Line-Outside.
(1)
(2)
600
0 : By calling party’s tenant/terminating
trunk’s tenant
1 : By Call Forwarding setting station’s
tenant
Select the Call Forwarding type when an
incoming call terminates via CCIS.
(1)
(2)
608
0 : As per CM65 Y=37/38/39
1 : As per CM65 Y=23/24/25
A
CM35
CM36
CM08
B
CALL FORWARDING
SPLIT CALL FORWARDING-BUSY LINE