– 204 – NWA-008845-001 Rev.5.0
32ch1004.fm
DESCRIPTION DATA
Assign the data for interpreting the digits
received.
NOTE: Day/Night Mode, Mode A/B can be
specified according to following
conditions.
1st priority:
Specified by tenant number for each
calling party number (CM76 Y=09)
2nd priority:
Specified by trunk tenant number
(CM30 Y=01)
3rd priority:
Specified by tenant number for each
DID number (CM76 Y=09)
•
•
•
•
(1)
(2)
Y=01 Day Mode
Y=02 Night Mode
Y=03 Mode A
Y=04 Mode B
000-999: Development Block No. assigned
by CM2A Y=50/51/52
X-XXXXXXXX: Station No. to be
terminated
DXX: Change Terminating System to:
D02: Trunk-Direct Appearances
D03: Trunk-Direct Appearances +
TAS
D04: Direct-In Termination
D09: Automated Attendant
D10: Attendant Console + TAS
D11: Attendant Console + Trunk-
Direct Appearances
D12: Attendant Console + Trunk-
Direct Appearances + TAS
D13: TAS
D14: Attendant Console
D16: DISA
When CM76 Y=01/02/03/04 is set to “D13”
(TAS), assign the terminating tenant for Day/
Night Mode, Mode A/B per each calling party
number.
•
•
•
•
(1)
(2)
Y=05 Day Mode
Y=06 Night Mode
Y=07 Mode A
Y=08 Mode B
000-999: Development Block No. assigned
by CM2A Y=50/51/52
00-63: Trunk Tenant No.
NOTE: When you set the other CM76 data (Y=10, 11, 13-16, 18-25) for the Development Block
number assigned by CM2A Y=50/51/52, these settings are also effective for each calling
party number.
B
CM76
END
CID CALL ROUTING
To Next Page
Loading...