Philips Sopho 2000 IPS - Page 306

– 288 – NWA-008845-001 Rev.5.0
32ch1005.fm
DESCRIPTION DATA
Assign the necessary functions to the DTI
card.
After entering the data, set the MB switch on
the DTI card to UP, and then to DOWN, for
DTI initialization.
NOTE: The following table shows the
relationship between CMAA Y=01
and CMAA Y=02.
•
(1)
(2)
Y=00 Data Mode
04-15, 20-31: AP No. assigned by CM05
Y=0
0: Based on AT&T Specifications
•
(1)
(2)
Y=01 Frame Configuration
04-15, 20-31: AP No. assigned by CM05
Y=0
0 : 12-Multi Frame (D4)
1 : 24-Multi Frame (ESF)
•
(1)
(2)
Y=02 Zero Code Suppression
04-15, 20-31: AP No. assigned by CM05
Y=0
0 : Available (Non Transparent)
1 : Not available (Transparent)
•
(1)
(2)
Y=03
04-15, 20-31: AP No. assigned by CM05
Y=0
7 : Associated Channel Interoffice Sig-
naling
Select the card for DTI T1 interface. •
(1)
(2)
Y=14
04-15, 20-31: AP No. assigned by CM05
Y=0
0 : PN-24PRTA/PN-DTA
1 : PN-24DTA-C
A
CMAA
DTI INITIAL
[ ]: Indicates 2nd data
CMAA Y=01
(FRAME
CONFIGURATION)
CMAA Y=02
(ZERO CODE
SUPPRES-
SION)
SIGNALING
24-Multi Frame [1] B8ZS
12-Multi Frame [0]
Not available
[1]
Transparent
Available [0] B7
INITIAL
B
JULY/01/2006
DIRECT DIGITAL INTERFACE
PROGRAMMING