– 318 – NWA-008845-001 Rev.5.0
32ch1006.fm
To abbreviate the ID Code entry when digit conversion on DID call is not provided
(CM35 Y=18 is set to “1”):
DESCRIPTION DATA
Assign the Number Conversion Block number
to the DID number.
•
(1)
(2)
Y=00
X-XXXX: DID No.
000-999: Number Conversion Block No.
000-999
Specify the terminating system as DISA. •
•
•
•
(1)
(2)
Y=01 Day Mode
Y=02 Night Mode
Y=03 Mode A
Y=04 Mode B
000-999: Number Conversion Block No.
assigned by CM76 Y=00
D16: DISA
Set the calling party number to be used as the
ID Code for DISA when the DID number as-
signed by CM76 Y=00 is sent.
•
(1)
(2)
Y=14
000-999: Number Conversion Block No.
assigned by CM76 Y=00
0: Available
Allow the service setting by DISA without di-
aling the ID Code.
•
(1)
(2)
Y=15
000-999: Number Conversion Block No.
assigned by CM76 Y=00
15 : Service setting without dialing the ID
Code
Assign the ID Code Development number, for
Call Forwarding set by DISA.
•
(1)
(2)
Y=A0
3: Automatic service setting by DISA
0-9: ID Code Development No. 00-09
Assign the calling party number as the ID
Code for DISA.
•
(1)
(2)
Y=00-09 ID Code Development No. 00-09
X-XX...XX: Calling Party No.
(Maximum 16 digits)
0000-2999: ID Code Pattern No.
C
CM76
CM2A
D
DIRECT INWARD SYSTEM ACCESS (DISA)
CALL FORWARDING SET BY DISA
To Next Page