Philips Sopho 2000 IPS - Page 346

– 328 – NWA-008845-001 Rev.5.0
32ch1006.fm
(4) For Direct Inward Dialing calls
• To distinguish by the trunk route
• To distinguish by the terminating DID number
DESCRIPTION DATA
Specify the interval of ringing tones for Direct
Inward Dialing calls.
(1)
(2)
180
0 : 0.4 seconds ON-0.2 seconds OFF-0.4
seconds ON-2 seconds OFF
1 : As per CM35 Y=33
DESCRIPTION DATA
Assign the interval of ringing tones as “As per
CM76 Y=22”.
(1)
(2)
180
1 : As per CM76 Y=22
Specify the interval of ringing tones on DID
calls.
For this assignment, do not set CM76 Y=22 to
3 (As per CM35 Y=33 (D
term
or SLT)).
•
(1)
(2)
Y=22
000-999: Number Conversion Block No.
assigned by CM76 Y=00/90
0: 0.5 seconds ON-0.5 seconds OFF
(D
term
)
1.0 second ON-2.0 seconds OFF (SLT)
1: 0.5 seconds ON-0.5 seconds OFF-
0.5 seconds ON-1.5 seconds OFF
(D
term
)
0.4 seconds ON-0.2 seconds OFF-
0.4 seconds ON-2.0 seconds OFF (SLT)
2: 1.0 second ON-2.0 seconds OFF (D
term
or SLT)
START
CM08
END
START
CM08
CM76
END
DISTINCTIVE RINGING