– 352 – NWA-008845-001 Rev.5.0
32ch1006.fm
To set the Do Not Disturb feature to the stations of SLT/sub line of D
term
/Virtual line stations that are ac-
commodated to the D
term
multiline as the sub line, and to display the Do Not Disturb Set/Reset status of
the stations on the lamp of D
term
:
[Series 3500 software required]
NOTE: To make available this feature, do the programming both of the setting side (D
term
) and the set
side (stations of SLT, sub line of D
term
or virtual line stations).
• For Setting Side (D
term
)
DESCRIPTION DATA
Assign Service Restriction Class C to the re-
quired stations.
•
(1)
(2)
Y=07
X-XXXXXXXX: Station No.
00-15 : Service Restriction Class C
Allow Do Not Disturb Setting in Service Re-
striction Class C assigned by CM12 Y=07.
•
(1)
(2)
Y=188
00-15: Service Restriction Class C assigned
by CM12 YY=07
0 : Allow
1 : Restricted
Assign the Do Not Disturb Lamp Indication on
Line/Trunk/Feature keys of D
term
.
•
(1)
(2)
Y=62
X-XXXXXXXX: Station No.
0 : Not indicated
1 : Not used
2 : Do Not Disturb Lamp Indication
3 : Message Waiting Lamp Indication
START
CM12
CM15
CM12
END
NOVEMBER/15/2006
DO NOT DISTURB
To Next Page
Loading...