Philips Sopho 2000 IPS - Page 373

– 355 – NWA-008845-001 Rev.5.0
32ch1006.fm
DESCRIPTION DATA
Specify the sending method of calling number
to the 911 Sender trunk.
•
(1)
(2)
Y=07 Sending method of calling number
04-15, 20-31: AP No. assigned by CM05
3: Enhanced 911
Set the trunk route that no answer signal ar-
rives from the distant office for outgoing con-
nection.
•
(1)
(2)
Y=04 Answer Signal from distant office
00-63: Trunk Route No.
3: No Answer signal (Polarity Reversal is
ignored)
Specify incoming connection signaling.
NOTE: DTI card must be set to Wink Start.
ODT card and COT card must be set
to Ring Down. Enhanced 911 will
not function if ODT card is set to
Wink Start.
•
(1)
(2)
Y=09 Incoming connection signaling
00-63: Trunk Route No.
03 : Wink Start
15 : Ring Down
Provide SMDR/Centralized Billing for outgo-
ing call.
•
(1)
(2)
Y=14 SMDR for outgoing call
00-63: Trunk Route No.
1: To provide
Specify sender start condition.
NOTE: Digital and Analog Tie Lines are set
to Wink Start. Analog Loop Start
Lines are set to Timing Start.
•
(1)
(2)
Y=20 Sender start condition
00-63: Trunk Route No.
00 : Wink Start
15 : Timing Start
Specify the trunk seizure pattern. •
(1)
(2)
Y=36 Trunk seizure pattern
00-63: Trunk Route No.
0: After dialing maximum number of digits
Provide the trunk route with Enhanced 911. •
(1)
(2)
Y=38 Enhanced 911
00-63: Trunk Route No.
0: Available
Specify the sending method of calling number
to the network.
•
(1)
(2)
Y=129 Sending method of calling number
00-63: Trunk Route No.
3: Enhanced 911
Assign the Area Code Development Pattern
number for maximum digit analysis.
•
(1)
(2)
Y=76 Area Code Development Pattern
00-63: Trunk Route No.
00-07: Area Code Development Pattern
No. 0-7
A
CMAA
CM35
B
ENHANCED 911