– 464 – NWA-008845-001 Rev.5.0
32ch1008.fm
MCI Programming
After AP Initialization, do the following programming.
Call Forwarding to the VMS stations, and UCD Group/Station Hunting Group set to the VMS stations are
required. For these feature programming, refer to each feature in this manual.
DESCRIPTION DATA
Specify the type of VMS which is accommo-
dated to the system.
NOTE: For VMS with MCI, set the 2nd data
“0”.
(1)
(2)
443
0 : Depends on CM12 Y=25
1 : VMS with DTMF
Specify the type of the VMS Station.
NOTE: CM12 Y=25 is effective only when
CM08>443 is set to “0”.
•
(1)
(2)
Y=25
X-XXXXXXXX: Station No.
(VMS station)
0 : VMS with DTMF
3: VMS with MCI
Specify MSG display on the D
term
.(1)
(2)
025
0: MSG (only)
1 : MSG X (X: Number of message)
Specify Message Waiting control from VMS
with MCI to all stations.
NOTE: MW lamp control is only available
to the stations in the opposite PBX
connected with CCIS via MCI.
Station dialing MW access codes
are not allowed over CCIS.
(1)
(2)
444
0 : Available
1 : Not available
Specify whether Message Waiting from the
VMS is provided for the called station when a
forwarded call is terminated to the VMS via
CCIS.
(1)
(2)
376
0: To provide
1: Not provided
START
CM08
CM12
CM08
A
MESSAGE CENTER INTERFACE (MCI)
PROGRAMMING
To Next Page
Loading...