Philips Sopho 2000 IPS - Page 56

– 38 – NWA-008845-001 Rev.5.0
32ch1001.fm
NOTE: Announcement Service can be used to provide a voice message when an incoming DID line/Tie
line call has been terminated to a station and encounters a busy or no answer condition. After
the voice message is given, normal call processing continues.
• This application can be programmed on a tenant basis.
• Only one (1) message of up to the following seconds can be recorded on an individual Digital
Announcement Trunk Circuit.
Built-in DAT on MP: 120 seconds
4DAT card: 120 seconds
DESCRIPTION DATA
Assign the function for each Digital
Announcement Trunk card.
•
(1)
(2)
Y=00
000-001: Built-in DAT on MP card
002-127: Digital Announcement Trunk No.
(EB002-EB127)
0D00: No Answer
0E00: Busy
Assign the Digital Announcement Trunk as the
destination of the DID call on each tenant.
•
•
(1)
(2)
Y=00 No Answer
Y=03 Busy
00-63: Tenant No.
EB000-EB127: Digital Announcement
Trunk No.
Assign the Digital Announcement Trunk as the
destination of the Tie Line call on each tenant.
•
•
(1)
(2)
Y=01 No Answer
Y=04 Busy
00-63: Tenant No.
EB000-EB127: Digital Announcement
Trunk No.
To record, replay and delete a message, assign
the respective Digital Announcement Trunk
access code.
•
(1)
(2)
Y=0-3 Number Plan Group 0-3
X-XXXX: Access Code
A100: Record
A101: Replay
A102: Delete
A
CM49
CM51
CM20
END
ANNOUNCEMENT SERVICE