– 592 – NWA-008845-001 Rev.5.0
32ch1009.fm
DESCRIPTION DATA
Assign the function of each Soft Key on each
status of the D
term
.
To the 2nd data of this command, the 2nd data
(F0XXX, F1XXX, F50XX) of CM90 should
be assigned except for Scroll key data (F5002).
The LCD shows a maximum of 4 Soft Keys at
once. If assigning more than 4 Soft Keys on
one status, it is necessary to assign Scroll key
at every 4 keys (on 1st through 4th display).
NOTE 1: Scroll key must be assigned as a key
for each active display.
NOTE 2: Help key is only available in Pattern
No. 3.
NOTE 3: For the Pattern No. 3, the initial Soft
Key data for NEAXMail AD-8/IM-
16 live recording is assigned. See
the following section.
NOTE 4: Pattern No. 3 is fixed.
NOTE 5: For Dial By Name assignment, refer
to DIAL BY NAME.
Page 259
•
(1)
Y=00-03 Soft Key Pattern No. 0-3 assigned
by CM12 Y=23
aa bb
aa: 00-15: Status No.
00: Idle State
01: During dialing (Holding no call)
02: During dialing (Holding station/
trunk)
03: During calling (Holding no call)
04: During calling (Holding station/
trunk)
05: Being called
06: When called party is busy
(Holding no call)
07: When called party is busy
(Holding station/trunk)
08: When called party sets DND
09: Trunk Busy
10: During Speaking (Holding no call)
11: During Speaking (Holding station/
trunk)
12: During live recording/after live re-
cording to NEAXMail AD-8/IM-16
NOTE 3
13-15: Not used
bb: Soft Key No. 00-15
00-03: Indicated on 1st display
04-07: Indicated on 2nd display
08-11: Indicated on 3rd display
12-15: Indicated on 4th display
(2) F5002 : Scroll key to change Soft Key
Indication
XXXXX: Setting of each function
(Same as “F0XXX, F1XXX,
F50XX” of CM90)
NONE : No data
A
CM9A
B
DECEMBER/02/2005
PROPRIETARY MULTILINE TERMINAL
SOFT KEY
To Next Page
Loading...