– 608 – NWA-008845-001 Rev.5.0
32ch1010.fm
When CM08>570 is set to 1, the associated access codes become as shown below, and these access codes
cannot be changed.
On Busy Tone Connection On Ring Back Tone Connection
1. None 1. Internal Tone/Voice Signaling NOTE 4
2. Call Back/Trunk Queuing-Outgoing 2. Call Back-Don’t Answer NOTE 1, 2, 4
NOTE 1, 2 3. None
3. Executive Override NOTE 1, 2 4. None
4. Camp-On 5. None
5. Call Waiting 6. Message Reminder/Message Waiting Set NOTE 4
6. Message Reminder/Message Waiting Set 7. None
7. Step Call (7 + Last one digit) NOTE 3 8. Message Waiting Record NOTE 4
8. Message Waiting Record 9. None
9. None
NOTE 1: This feature cannot be set from Attendant Console.
NOTE 2: This feature cannot be set from a station having a held call.
NOTE 3: This feature can be set only from a station having a held incoming call.
NOTE 4: From a DTMF telephone, a hooking operation is required before dialing the single digit access
code.
This feature is mutually exclusive with Step Call.
However, 2 digit dialing Step Call can be provided by using this feature.
DECEMBER/02/2005
SINGLE DIGIT FEATURE ACCESS CODE
To Next Page
Loading...