– 673 – NWA-008845-001 Rev.5.0
32ch1010.fm
(3) To provide the One Touch key to send “Hooking Signal + Called Number” to a Centrex, set the
following data in addition to the programming (2).
(4) To provide the One Touch key to send “Called Number + DTMF Signal” for such as VMS operation,
set the following data in addition to the programming (2), when the called number includes a trunk
access code. If the called number includes no trunk access code, this data is not required.
DESCRIPTION DATA
Assign the access code for sending of a Hook-
ing signal to a Centrex.
Maximum of two digits are available.
•
(1)
(2)
Y=0-3
X-XXXX: Access code
A158: Hooking signal to a Centrex
Assign a RECALL key on the D
term
. RECALL
key is used to return to a former line.
•
(1)
(2)
Y=00
My Line No. + + Key No. (90)
F1015: RECALL
Provide Centrex trunk route with Centrex
function.
•
(1)
(2)
Y=86
00-63: Trunk Route No.
0: Centrex
DESCRIPTION DATA
Specify whether to set consecutive dialing
“* #” as a delimiter between the called number
and the DTMF signal.
(1)
(2)
448
0 : * # set as dialed digit
1 : Delimiter between called number and
DTMF signal
START
CM20
CM90
,
CM35
END
START
CM08
END
STATION SPEED DIALING
To Next Page
Loading...