– 753 – NWA-008845-001 Rev.5.0
32ch1011.fm
To transfer a call from an Attendant or a station to a VMS by dialing of a Single Digit Feature Access Code
“9” or by pushing a function key, while hearing RBT or BT from the destination station:
To provide a D
term
with One Touch keys to send Called Number + DTMF Signal after the called party an-
swered, for VMS operations (such as “VMS Extension number + Mail Box number or Password”), refer
to the programming (2), (4) in the “STATION SPEED DIALING”. Page 671, Page 673
HARDWARE REQUIRED
For interfacing to a VMS with Analog Dialogic Board: LC card
For interfacing to a VMS with Digital Dialogic Board: DLC card
For providing the Single-Line Telephone with a Message Waiting Lamp: 4LCD/8LC card
For providing the D
term
: DLC card
DESCRIPTION DATA
Specify whether dialing of the Single Digit
Feature Access Code is available or not while
hearing RBT.
(1)
(2)
156: Single Digit Feature Access Code
while hearing RBT
0 : Available
1 : Not available
Specify whether dialing of the Single Digit
Feature Access Code is available or not while
hearing BT.
(1)
(2)
208: Single Digit Feature Access Code
while hearing BT
0 : Available
1 : Not available
Specify the destination VMS station number
by transferring with Single Digit Feature Ac-
cess Code or a function key.
The first data should be the tenant number of
the destination station called.
•
(1)
(2)
Y=18 Destination VMS No. assignment
00-63: Tenant No.
X-XXXXXXXX: VMS Pilot No.
To the DESKCON or the D
term
, assign a func-
tion key to transfer a call to a VMS while hear-
ing RBT or BT, if required.
•
(1)
(2)
Y=00
ATTCON No. (E000-E007) + + Key
No.
F6123: Transferring to VMS
(1)
(2)
My Line No. + + Key No.
F5001: Transferring to VMS
START
CM08
CM51
CM90
,
,
END
VOICE MAIL TRANSFER
To Next Page
Loading...