PREVOST LE MIRAGE XLII BUS SHELLS User Manual

SERIES 60 SERVICE MANUAL
Remove the solenoid valve as follows:
NOTICE:
To avoid possible engine damage, do not disassemble
or tamper with the solenoid valve.
1. Disconnect solenoid valve harness.
2. Using a 7/8 in. socket and extension for former solenoids or a 3/4 in., 6 point socket and
extension for current solenoids, unscrew solenoid valve.
3. Remove and discard the three rubber seal rings. See Figure 1-422.
1. Seal Rings (3) 2. Solenoid
Figure 1-422 Removing Rubber Seal Rings
4. If the lower ring stays in the bottom of the housing bore, remove with a piece of wire.
All information subject to change without notice.
6SE483 9901 Copyright © 1999 DETROIT DIESEL CORPORATION From Bulletin 16-60-99 1-535

PREVOST LE MIRAGE XLII BUS SHELLS Specifications

General

Brand	PREVOST
Model	LE MIRAGE XLII BUS SHELLS
Category	Buses
Language	English