Chapter 8 Extended Data Lifecycle Management
Incomplete EDLM Scans
Scalar i500 User’s Guide 236
Item Description
CM Scan Status One of the following:
• Complete — Test is finished; however, the result may not be “good.” You
can also get this if the test was stopped. For details, see the CM Scan
Analysis.
• Paused
• Pending
•Not Run — For details see the CM Scan Analysis
•In Progress
• Stopped
CM Scan
Analysis
One of the following:
•Good
•N/A
• Failed to receive CM data
• CM hardware failure
• Tape reached 99% of the manufacturer defined number of tape
thread/load operations
• Tape reached 99% of the manufacturer defined number of full tape
capacity write operations
• CM indicates uncorrected errors on the tape
• Unable to load tape
• Unable to unload tape
• Tape not present
• No compatible drive
• I/O Blade Component Failure
To Next Page
Loading...
