Quantum Scalar i500 User Manual

Chapter 12 Installing, Removing, and Replacing
Permanently Removing Expansion Modules From an Existing Library
Scalar i500 User’s Guide 379
2 Add the tape drives to the modules. For details, see Adding,
Removing, and Replacing Tape Drives on page 444.
3 Add the power supplies. For details, see Adding, Removing, and
Replacing Power Supplies on page 420.
4 If your library contains FC I/O blades, install both the I/O blades
and the accompanying fan blades in the expansion module. For
details, see Adding, Removing, and Replacing FC I/O Blades
on
page 449 and Adding, Removing, and Replacing the FC I/O Fan
Blade on page 460.
5 Unpark the robot assembly.
a Gently raise the robot assembly so that it no longer rests on the
parking tab.
1 Y-rail in unlocked, functional
position

Quantum Scalar i500 Specifications

General

Form Factor	Rack-mountable
Product Type	Tape Library
Weight	Varies by configuration
Power Consumption	Varies by configuration
Drive Support	LTO-8, LTO-7, LTO-6
Management	Web-based remote management
Drive Type	LTO Ultrium
Supported Media	LTO-5, LTO-6, LTO-7, LTO-8
Operating Temperature	10°C to 35°C
Humidity	20% to 80% (non-condensing)
Interface	SAS