Chapter 12 Installing, Removing, and Replacing
Removing and Replacing the Library Control Blade and LCB Compact Flash Card
Scalar i500 User’s Guide 409
Instructions
12
The Compact Flash Card is new and has never been initialized. It contains
only a minimal level of library firmware which allows the library to boot
up and display an Upgrade Notification message. Once you install the
LCB/compact flash card, you will need to upgrade firmware and
reconfigure your network settings.
1 If possible, save the library configuration (see Saving the Library
Configuration on page 495).
2 Power off the library.
3 Disconnect all cables from the existing LCB. You may want to label
each cable that is connected to the existing LCB to make sure that you
can correctly reconnect them to the new LCB.
4 Remove the existing LCB from the library.
To remove the existing LCB, release both of the LCB latch hooks and,
using the latch hooks as handles, pull the entire LCB toward you.
Note: Do not separate the old compact flash card from the library
control blade (unless you are replacing the compact flash card
only). Return the old LCB/compact flash card as a pair to
Quantum.
To Next Page
Loading...
Need help?
General
