Quantum Scalar i500 User Manual

Chapter 12 Installing, Removing, and Replacing
Adding, Removing, and Replacing FC I/O Blades
Scalar i500 User’s Guide 455
4 Carefully align the FC I/O blade with the guide slots in the bay. The
status LEDs must be at the bottom.
5 Evenly apply pressure to both sides of the blade and slide it into the
expansion module until the latch hooks begin to move toward the
middle of the blade. Push the latch hooks toward the middle of the
1 FC I/O blade
2LEDs
3 Latch hooks, open
Caution: Forcing the blade into the bay can cause the pins to
bend.

Quantum Scalar i500 Specifications

General

Form Factor	Rack-mountable
Product Type	Tape Library
Weight	Varies by configuration
Power Consumption	Varies by configuration
Drive Support	LTO-8, LTO-7, LTO-6
Management	Web-based remote management
Drive Type	LTO Ultrium
Supported Media	LTO-5, LTO-6, LTO-7, LTO-8
Operating Temperature	10°C to 35°C
Humidity	20% to 80% (non-condensing)
Interface	SAS