R&S FSW Series - Reference: Command Set of Emulated PSA Models

Remote Commands
R&S
®
FSW
1363User Manual 1173.9411.02 ─ 43
Bit enabled by RQS Description
4 Command Complete
5 Illegal Command
6 Service Request
7 not used (value 0)
Bits 0 and 7 are not used and always have the value 0.
Please note that the R&S FSW reports any key pressed on the front panel rather than
only the unit keys if bit 1 was enabled.
Another difference is the behavior of bit 6 when using the STB? query. On the HP ana-
lyzers this bit monitors the state of the SRQ line on the bus. On the R&S FSW this is
not possible. Therefore this bit is set, as soon as one of the bits 1 to 5 is set. It won't be
reset by performing a serial poll.
14.13.3 Reference: Command Set of Emulated PSA Models
The R&S FSW analyzer family supports a subset of the GPIB commands of PSA89600
and ESA instruments.
Despite the differences in system architecture and device features, the supported com-
mands have been implemented in a way to ensure a sufficiently high degree of corre-
spondence with the original.
In many cases the selection of commands supported by the R&S FSW is sufficient to
run an existing GPIB program without adaptation.
Supported 89600 commands
*CAL?
*CLS
*ESE
*ESR?
*IDN?
*IST?
*OPC
*OPT?
*PCB
*PRE
*PSC
*RST
*SRE
Emulating Other Instruments' Commands