Measurements and Results
R&S
®
FSW
286User Manual 1173.9411.02 ─ 43
Remote command:
[SENSe:]LIST:RANGe<ri>[:FREQuency]:STARt on page 924
[SENSe:]LIST:RANGe<ri>[:FREQuency]:STOP on page 925
Filter Type
Sets the filter type for this range.
For details on filter types, see Chapter 8.5.1.6, "Which Data May Pass: Filter Types",
on page 463.
Remote command:
[SENSe:]LIST:RANGe<ri>:FILTer:TYPE on page 956
RBW
Sets the RBW value for this range.
For details on the RBW, see Chapter 8.5.1.1, "Separating Signals by Selecting an
Appropriate Resolution Bandwidth", on page 460.
Remote command:
[SENSe:]LIST:RANGe<ri>:BANDwidth:RESolution on page 954
VBW
Sets the VBW value for this range.
For details on the VBW, see Chapter 8.5.1.2, "Smoothing the Trace Using the Video
Bandwidth", on page 460.
Remote command:
[SENSe:]LIST:RANGe<ri>:BANDwidth:VIDeo on page 955
Sweep Time Mode
Activates or deactivates the auto mode for the sweep time.
For details on the sweep time mode, see Chapter 8.5.1.7, "How Long the Data is Mea-
sured: Sweep Time", on page 464
Remote command:
[SENSe:]LIST:RANGe<ri>:SWEep:TIME:AUTO on page 961
Sweep Time
Sets the sweep time value for the range.
For details on the sweep time, see Chapter 8.5.1.7, "How Long the Data is Measured:
Sweep Time", on page 464
Remote command:
[SENSe:]LIST:RANGe<ri>:SWEep:TIME on page 960
Detector
Sets the detector for the range.
For details, refer to "Mapping Samples to sweep Points with the Trace Detector"
on page 575.
Remote command:
[SENSe:]LIST:RANGe<ri>:DETector on page 956
Spurious Emissions Measurement
To Next Page
Loading...
Need help?
General
