R&S FSW Series - Time Domain Power Configuration

Measurements and Results
R&S
®
FSW
309User Manual 1173.9411.02 ─ 43
between signal and noise power of a TDMA signal for instance can be measured by
using a measurement as a reference value and then varying the measurement range.
In order to get stable measurement results for a limited evaluation range, usually a trig-
ger is required.
7.9.4 Time Domain Power Configuration
Access: "Overview" > "Select Measurement" > "Time Domain Power" > "Time Dom
Power Config"
The remote commands required to perform these tasks are described in Chap-
ter 14.5.10, "Measuring the Time Domain Power", on page 977.
Results........................................................................................................................ 310
Limit State................................................................................................................... 310
Left Limit / Right Limit..................................................................................................310
Time Domain Power Measurement