R&S FSW Series User Manual

Remote Commands
R&S
®
FSW
1330User Manual 1173.9411.02 ─ 43
<ChannelName> String containing the name of the channel.
The parameter is optional. If you omit it, the command works for
the currently active channel.
14.12 Commands for Remote Instrument Operation
The following commands are required to shutdown or reboot the R&S FSW from a
remote PC.
SYSTem:CLOGging..................................................................................................... 1330
SYSTem:REBoot..........................................................................................................1330
SYSTem:SHUTdown.................................................................................................... 1330
SYSTem:CLOGging <State>
This command turns logging of remote commands on and off.
Parameters:
<State> ON | OFF | 1 | 0
ON | 1
Writes all remote commands that have been sent to a file.
The destination is C:\R_S\INSTR\ScpiLogging\
ScpiLog.<no.>.
where <no.> is a sequential number
A new log file is started each time logging was stopped and is
restarted.
OFF | 0
*RST: 0
Manual operation: See "I/O Logging" on page 788
SYSTem:REBoot
This command reboots the instrument, including the operating system.
SYSTem:SHUTdown
This command shuts down the instrument.
14.13 Emulating Other Instruments' Commands
The R&S FSW analyzer family supports a subset of the GPIB commands of several
HP and PSA instruments.
For details see Chapter 13.2, "GPIB Languages", on page 769.
Emulating Other Instruments' Commands

R&S FSW Series Specifications

General

Brand	R&S
Model	FSW Series
Category	Measuring Instruments
Language	English