R&S FSW Series User Manual

Remote Commands
R&S
®
FSW
1049User Manual 1173.9411.02 ─ 43
<t> Trace
Parameters:
<ScalingType> LOGarithmic
Logarithmic scaling.
LINear
Linear scaling in %.
LDB
Linear scaling in the specified unit.
PERCent
Linear scaling in %.
*RST: LOGarithmic
Example:
DISP:TRAC:Y:SPAC LIN
Selects linear scaling in %.
Manual operation: See "Scaling" on page 458
14.7.4 Configuring Triggered and Gated Measurements
The commands required to configure a triggered or gated measurement in a remote
environment are described here.
The tasks for manual operation are described in Chapter 8.6, "Trigger and Gate Con-
figuration", on page 476.
The commands required for trigger input or output are described in Chapter 14.7.4.3,
"Configuring the Trigger Output", on page 1061.
*OPC should be used after requesting data. This will hold off any subsequent changes
to the selected trigger source, until after the sweep is completed and the data is
returned.
● Configuring the Triggering Conditions.................................................................1049
● Configuring Gated Measurements...................................................................... 1055
● Configuring the Trigger Output............................................................................1061
● Programming Example: Continuous Gating........................................................1063
14.7.4.1 Configuring the Triggering Conditions
The following commands are required to configure a triggered measurement.
TRIGger[:SEQuence]:DTIMe.........................................................................................1050
TRIGger[:SEQuence]:HOLDoff[:TIME]............................................................................1050
TRIGger[:SEQuence]:IFPower:HOLDoff.........................................................................1050
TRIGger[:SEQuence]:IFPower:HYSTeresis.....................................................................1051
TRIGger[:SEQuence]:LEVel[:EXTernal<port>].................................................................1051
TRIGger[:SEQuence]:LEVel:IFPower............................................................................. 1052
TRIGger[:SEQuence]:LEVel:IQPower.............................................................................1052
TRIGger[:SEQuence]:LEVel:RFPower............................................................................1052
Setting Basic Measurement Parameters

R&S FSW Series Specifications

General

Brand	R&S
Model	FSW Series
Category	Measuring Instruments
Language	English