R&S FSW Series - Using Service Functions

Remote Commands
R&S
®
FSW
1308User Manual 1173.9411.02 ─ 43
CONFigure:GENerator:CONNection[:STATe] <State>
Connects or disconnects the signal generator specified by CONFigure:GENerator:
IPConnection:ADDRess on page 1308. The IP address must be specified before
you use this command.
Parameters:
<State> ON | OFF | 0 | 1
OFF | 0
Disconnects the generator.
ON | 1
Connects the generator.
*RST: 0
Example:
CONF:GEN:IPC:ADDR '192.168.114.90'
CONF:GEN:CONN:STAT ON
Manual operation: See "Connect/Disconnect" on page 229
See "Test Connection" on page 711
CONFigure:GENerator:IPConnection:ADDRess <IPAddress>
The TCPIP address or computer name of the signal generator connected to the
R&S FSW via LAN.
The IP address / computer name is maintained after a [PRESET], and is transferred
between applications.
Parameters:
<IPAddress> IP address or computer name
Example:
CONF:GEN:IPC:ADDR '192.168.114.90'
Manual operation: See "IP Address / Computer Name" on page 228
See "IP Address or Computer name of Signal Generator"
on page 711
14.10.10 Using Service Functions
DIAGnostic:SERVice:SFUNction....................................................................................1308
DIAGnostic:SERVice:SFUNction:LASTresult?.................................................................1309
DIAGnostic:SERVice:SFUNction:RESults:DELete........................................................... 1309
DIAGnostic:SERVice:SFUNction:RESults:SAVE..............................................................1309
DIAGnostic:SERVice:SINFo?........................................................................................ 1309
SYSTem:PASSword[:CENable]......................................................................................1310
SYSTem:PASSword:RESet........................................................................................... 1310
DIAGnostic:SERVice:SFUNction <ServiceFunction>
This command starts a service function.
Configuring the R&S
FSW