R&S FSW Series - How to Perform Channel Power Measurements

Measurements and Results
R&S
®
FSW
194User Manual 1173.9411.02 ─ 43
Figure 7-34: Channel name definition for asymmetric adjacent channels
Remote command:
[SENSe:]POWer:ACHannel:SBLock<sb>:NAME[:CHANnel<ch>] on page 887
[SENSe:]POWer:ACHannel:NAME:ACHannel on page 845
[SENSe:]POWer:ACHannel:NAME:ALTernate<ch> on page 846
[SENSe:]POWer:ACHannel:NAME:UACHannel on page 887
[SENSe:]POWer:ACHannel:NAME:UALTernate<ch> on page 887
7.2.6 How to Perform Channel Power Measurements
The following step-by-step instructions demonstrate the most common tasks when per-
forming channel power measurements.
For remote operation, see Chapter 14.5.3.10, "Programming Examples for Channel
Power Measurements", on page 891.
Channel Power and Adjacent-Channel Power (ACLR) Measurement