To Next Page

To Previous Page

Applications, Measurement Channels, and Operating Modes

R&S

FSW

130User Manual 1173.9411.02 ─ 43

Remote command:

INITiate:SEQuencer:MODE on page 830

6.4.3 How to Set Up the Sequencer

In order to perform the configured measurements consecutively, a Sequencer function

is provided.

1. Configure a channel for each measurement configuration as required, including the

sweep mode.

2. In the toolbar, select the "Sequencer" icon.

The "Sequencer" menu is displayed.

3. Toggle the "Sequencer" softkey to "On".

A continuous sequence is started immediately.

4. To change the Sequencer mode and start a new sequence immediately, select the

corresponding mode softkey, or press the [RUN SINGLE] or [RUN CONT] key.

The measurements configured in the currently active channels are performed one

after the other in the order of the tabs until the Sequencer is stopped.

The result displays in the individual channels are updated as the measurements

are performed.

To stop the Sequencer

► To stop the Sequencer temporarily, press the highlighted [RUN SINGLE] or [RUN

CONT] key (not for a channel-defined sequence). To continue the Sequencer,

press the key again.

To stop the Sequencer permanently, select the "Sequencer" icon in the toolbar and

toggle the "Sequencer" softkey to "Off".

Running a Sequence of Measurements

R&S FSW Series User Manual

Questions and Answers: