Remote Commands
R&S
®
FSW
823User Manual 1173.9411.02 ─ 43
*TST?
Self-test query
Initiates self-tests of the instrument and returns an error code.
Note: If you start a self-test remotely, then select the "Local" softkey while the test is
still running, the instrument only returns to the manual operation state after the test is
completed. In this case, the self-test cannot be aborted.
Return values:
<ErrorCode> integer > 0 (in decimal format)
An error occurred.
(For details, see the Service Manual supplied with the instru-
ment).
0
No errors occurred.
Usage: Query only
*WAI
Wait to continue
Prevents servicing of the subsequent commands until all preceding commands have
been executed and all signals have settled (see also command synchronization and
*OPC).
Usage:
Event
14.4 Selecting the Operating Mode and Application
The following commands are required to select the operating mode or the application
and to configure a Sequencer in a remote environment.
The tasks for manual operation are described in Chapter 6, "Applications, Measure-
ment Channels, and Operating Modes", on page 115.
● Selecting the Mode and Applications....................................................................823
● Performing a Sequence of Measurements............................................................829
● Programming Example: Performing a Sequence of Measurements.....................831
14.4.1 Selecting the Mode and Applications
DISPlay:ATAB................................................................................................................824
INSTrument:CREate:DUPLicate...................................................................................... 824
INSTrument:CREate[:NEW]............................................................................................ 824
INSTrument:CREate:REPLace........................................................................................ 825
INSTrument:DELete....................................................................................................... 825
INSTrument:LIST?......................................................................................................... 825
Selecting the Operating Mode and Application