R&S FSW Series User Manual

Network and Remote Operation
R&S
®
FSW
816User Manual 1173.9411.02 ─ 43
4. To prevent unintentional return to manual operation, disable the keys of the instru-
ment using the universal command LLO.
Switching to manual mode is only possible via remote control then. This function is
only available for the GPIB interface.
5. To enable the keys of the R&S FSW again, switch the instrument to local mode
(GTL - Go to Local), i.e. deactivate the REN line of the remote control interface.
If the instrument is operated exclusively in remote control, it is recommended that you
switch off the display. For details see "Remote Display Update" on page 788.
13.6.9 How to Return to Manual Operation
Before you switch back to manual operation, all remote command processing must be
completed. Otherwise, the instrument will switch back to remote control immediately.
► Select the "Local" softkey, or use the following GPIB command:
status = viGpibControlREN(vi, VI_GPIB_REN_ADDRESS_GTL)
If you select the "Local" softkey while a self-alignment or a self-test is still running
(which was started remotely), the instrument only returns to the manual operation state
when the alignment or test is completed.
How to Set Up a Network and Remote Control

R&S FSW Series Specifications

General

Brand	R&S
Model	FSW Series
Category	Measuring Instruments
Language	English