Remote Commands
R&S
®
FSW
917User Manual 1173.9411.02 ─ 43
NPR:NOTC1:BWID 3.600000
NPR:NOTC2:FREQ:OFFS 12200000
NPR:NOTC2:BWID:REL 5
//--------------Performing the Measurement-----
//Select single sweep mode.
INIT:CONT OFF
//Initiate a new measurement and wait until the sweep has finished.
INIT;*WAI
//---------------Retrieving Results-------------
//Query the noise power ratio for each notch.
CALC:NPR:RES? ALL
//Result:
//9.38,-51.73,-4685,-61.10,-56.26
//Query the measured power in each trace point
TRAC:DATA? TRACe1
//Returns 1001 power values
14.5.7 Measuring the Spectrum Emission Mask
All remote control commands specific to spectrum emission mask measurements are
described here.
See also Chapter 14.5.2, "Configuring Power Measurements", on page 837.
Remote commands exclusive to spectrum emission mask measurements:
● Managing Measurement Configurations............................................................... 918
● Controlling the Measurement................................................................................919
● Configuring a Multi-SEM Measurement................................................................ 920
● Configuring a Sweep List...................................................................................... 921
● Configuring the Reference Range.........................................................................935
● Configuring the Power Classes.............................................................................937
● Configuring MSR SEM Measurements................................................................. 942
● Configuring the List Evaluation............................................................................. 948
● Performing an SEM Measurement........................................................................950
● Retrieving Results.................................................................................................950
● Example: SEM Measurement............................................................................... 950
Configuring and Performing Measurements
To Next Page
Loading...
Need help?
General
