R&S FSW Series - System Configuration Settings; Hardware Information

General Instrument Setup
R&S
®
FSW
703User Manual 1173.9411.02 ─ 43
When you switch the input source, the previously defined settings are restored. You
can restore the default values for all input sources using the "Preset Channel" function.
12.6 System Configuration Settings
Access: [Setup] > "System Configuration"
● Hardware Information............................................................................................703
● Information on Versions and Options....................................................................704
● System Messages.................................................................................................705
● Firmware Updates.................................................................................................706
● General Configuration Settings.............................................................................708
● Signal Generator Settings.....................................................................................710
12.6.1 Hardware Information
Access: [Setup] > "System Configuration" > "Hardware Info"
An overview of the installed hardware in your R&S FSW is provided.
Every listed component is described by its serial number, order number, model infor-
mation, hardware code, and hardware revision.
This information can be useful when problems occur with the instrument and you
require support from Rohde & Schwarz.
Remote command:
DIAGnostic:SERVice:HWINfo? on page 1302
System Configuration Settings